If you have Sonar 6, you can use it as a generic ACT controller to learn all the fader movements, then set up ACT to matching mode so you don't get stuff jumping all over the place.

And can communicate it clearly.įirst of all, DDX3216 is NOT a control surface but it can be used as one. You should sit back and read what the informed users are saying instead of raising the noise-to-signal ratio here because there are some VERY informed cats on this board who really know their stuff. Every one of them within an hour span and just hopping into threads to type random nonsense. I mean, my god man, look at your most recent posts.

The amazing CJ who posts misspelled misinformation on every topic despite no knowledge about the question. So I will take you statement with a pinch of whatever.Īs for the LCD failures, the element conductive pads get stressed and do not conduct,dissasemble clean ,reassemble, replace caps and reflow all the tosh chips, 99% success.Wow. PSU issues are the bain of many problems associated with the desk ,recapping is essential, and then setting up the voltage presets/current draw is paramount to trouble free operation.Īll the parts,chips etc required to repair are available.except the hex code for 2 of the PIC Chips,which of course are protected !(CPU board and ADAT card io) Most are caused by user ignorance and abuse, and exposure to high moisture levels !, Repaired about 10 so far with total success, Just depends on how far your understanding of the beast goes, The audio sections have been modded and all Digital glitches removed with NO issues,and those that had issues ,were resolved. Well yes they did have issues.still using 3 here. They are all doorstops if they don't work.? While mucking around with the internal connection, I can force the LCD panel to show a all black screen by improperly connecting the connector, so it MIGHT not be the LCD fault.Īny kind soul here have and opinions on the matter?ĭesperately need help coz there is no one else around in my country that I know of that will fix the mixer and I am left to my own devices now. I literally have to plant my eyeball 2 cm from the screen to see anything!

The lcd screen on my DDX3216 has gradually faded to a point that it takes almost 2+ hours for it to 'warm up' and all i can see is a faint image on the screen. This is why I need new sets of panels.I am also facing the same problem of gradually fading screen. Everything faded out slowly until nothing but just a backlight can be seen. Not really an easy thing to do and you have to be very careful in removing the lcd panel and the circuit board that connects to it.

Loose connection in the LCD rubber connector may be doing that. I think that might be an easier problem if you do component level repair.

Behringer ddx3216 software download